FUTABA 14SG S.Bus2 - Page 23

23
<Before Use>
When exchanging for the LiFe battery
(FT2F2100B/FT2F1700B) of an option.
Attachment of the battery
1. T14SG to HT5F1800B is removed.
2. A LiFe spacer (14SG attachment) is inserted
as shown in a gure.
3. A LiFe battery (option) is inserted as shown in
a gure.
4.2P connector of a LiFe battery is
connected.
5. Close the battery cover completely.
6.T14SG is turned on and [LINKAGE
MENU]=>[WARNING]=>[LOW BATTERY] is
called.
7. It changes into 6.0V from 5.6V.
Charge of a LiFe battery
Note: LiFe battery cannot be charged with the
charger of 14SG attachment.
Be sure to remove a battery from T14SG and to
charge from the charger only for LiFe.
Warning
Follow the manual of a LiFe battery.
Don't charge the LiFe battery with the
NiMH charger of 14SG attachment.
* Be sure to remove from T14SG and to charge with
the charger only for LiFe.
Be sure to change the voltage of LOW
BATTERY WARNING into 6.0V from
5.6V
LiFeSPACER
LiFe
Battery
Thebalancechargeconnectorisnotconnected
inthestatewherethebatteryissettoatransmitter.
ALiFe
batteryis
removed
fromT14SG.
Balancecharge
iscarriedoutfromthechargeronlyforLiFe.
2Pconnectoris
removedfromT14SG.
ThebatterystateinsideT14SG
NiMHHT5F1800B
LiFeFT2F2100B/1700B
LiFeSPACER
*About low battery voltage, all the models included in one
transmitter are changed in common. It cannot set to different
voltage for every model. Moreover, data reset is not carried
out.