FUTABA 14SG S.Bus2 - Page 72

168 pages

To Next Page

To Previous Page

Model type selection (Airplane, Glider)

●Wing type (Normal)

 

●Wing type (Tailless wing)

 

●Rudder type



●Tail type

 

Model type selection (Helicopter)

●Swash type

Main Page

Table of Contents2
Introduction4
Support and Service4
Application, Export, and Modification5
Definitions of Symbols6
Safety Precautions (Do Not Operate Without Reading)6
Before Use10
Features of 14SG10
Contents and Technical Specifications11
Accessories12
Transmitter Controls13
- Cautions on Handling Antenna14
- LED Monitor14
- Switch (SA-SH)15
- Digital Trim (T1-T4)15
- Volume (LD, RD)15
- Slide Lever (LS, RS)15
- HOME/EXIT, U.MENU/MON. Button15
- Touch Sensor16
- Stick Adjustment17
- SD Card19
- Connector/Plug21
- Installation and Removal of the Battery22
Receiver Nomenclature24
Receiver's Antenna Installation26
Safety Precautions When Installing Servos27
S.BUS/S.BUS2 Installation28
S.BUS Wiring Example29
S.BUS2 System30
S.BUS/S.BUS2 Devicesetting31
Telemetry System32
Basic Operation33
Battery Charging33
- How to Charge the Nimh Battery33
How to Turn ON/OFF the Transmitter34
- When Turning on34
- When Turning off34
- Low Battery Alarm and Auto Shut-Down34
- Warning Display at Power on34
Registration of the User's Name34
Home Screen35
- User Menu36
Link Procedure (T14SG/R7008SB)37
Range Check Mode/Procedure39
Range Testing Your R/C System39
Raceiver and Servo Installation40
Receiver and Servos Connection40
Servo Connection by Model Type41
Model Basic Setting Procedure44
Airplane/Glider Basic Setting Procedure44
Helicopter Basic Setting Procedure46
Functions of System Menu50
- Trainer51
- Display54
- User Name55
- Sound56
- H/W Setting57
- Start SEL59
- Auto Lock62
- Information63
- SBUS Servo64
Functions of Linkage Menu67
(Common Functions) Linkage Menu Functions Table67
- Servo Monitor68
- Model Select69
- Model Type71
- System73
- Function76
- Sub-Trim78
- Servo Reverse79
- Fail Safe80
- End Point81
- Servo Speed82
- Throttle Cut (Air/Heli Only)83
- Idle down (Air Only)84
- Swash Ring (Heli Only)85
- Swash (Heli Only, Except H-1)86
- T1-T4 Setting89
- Warning90
- Telemetry91
- Telemetry:rx-Batt92
- Telemetry:ext-Volt93
- Telemetry:temp94
- Telemetry:rpm95
- Telemetry:altitude96
- Telemetry:vario97
- Telemetry:battery98
- Telemetry:distance99
- Telemetry:speed101
- Sensor102
- Sensor:reload103
- Sensor:register103
- Sensor:relocate104
- Sensor:set Slot104
- Data Reset105
Functions of Model Menu106
Common Functions106
- Servo Monitor (Linkage Menu) Condition Select (Glid/Heli Only)107
- Dual Rate109
- Program MIX111
- Fuel MIX (Air/Heli Only)113
Airplane/Glider Functions115
- Model Menu Functions List115
- Pitch Curve (Air/Glid)117
- Throttle Curve (Air Only)118
- THR Delay (Air Only)119
- AIL Differential (Except 1-AIL)120
- Flap Setting (2-FLP and Up)121
- AIL to Camber FLP (2-AIL+2-FLP and Up)122 AIL to Brake FLP (Glid Only, 4-FLP)123
- AIL to RUD124
- RUD to AIL125
- Camber MIX (Except 1-AIL)127
- ELE to Camber (Except 1-AIL)129
- Butterfly (Glid Only, Normal Wing 2-AIL and Up, Flying Wing 2-AIL+1FLP and Up)131
- Trim MIX (Glid Only, 2-AIL and Up)133
- Airbrake (Air Only, 2-AIL and Up)135
- Gyro (Air Only, for GYA Type Gyro)137
- V-Tail139
- Ailevator140
- Winglet (Flying Wing Only)141
- Motor142
- RUD to ELE (Air Only)144
- Snap Roll (Air Only)145
Helicopter Functions147
- Model Menu Functions List147
- PIT Curve/Pit Trim148
- THR Curve/Throttle Hover Trim/Throttle151
- Limiter151
- Throttle Hold154
- Swash MIX155
- Throttle MIX156
- PIT to RUD (Revolution MIX)157
- Gyro (for GY Type Gyro)158
- Governor161
Appendix164
- Timer ST1/ST2164
- Switch Setting Method166

FUTABA 14SG S.Bus2 - Page 72

Table of Contents