FUTABA T10PX - Page 114

114
Returntotableofcontents
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
* Throttle trigger position
* Throttle trigger position
Warning
Setting the speed function in the return direction slows the deceleration of the car body, so
please be careful to set it carefully.
2
("Low", Middle", and "High" return direction delay adjustment)
Tap the [Return] side of [Low], [Middle]
or [High] value button. A warning is dis-
played saying, "Return speed will be
slow. Please be careful.". If you want to
use the return, tap [Close]. Value input
buttons appear on the screen. Use the [+]
and [-] buttons to adjust the return speed
amount.
3
(Speed switching point adjustment)
When you want to change the "Low", "Mid-
dle" and "High" switching point, tap the [point
1] or [point 2] value button. Value input but-
tons appear on the screen, use the [+] or
[-] buttons to move to the point you want to
set.
1001
Servo operation is delayed.
Point
Point 1: 1~100
Point 2: 1~100
Initial value point 1: 30
Initial value point 2: 60
Speed range
High: 1~100
Middle: 1~100
Low: 1~100
Initial value :
100, there is no delay.
4
When finished, return to the Racing menu screen by pressing the HOME button twice.
The throttle speed adjustment
"
Tu r n
"
and
"
Return
"
adjustment can be controlled
with digital trim DT1 to DT6 or digital dial DL1 etc. with the trim/dial select func-
tion. (Linkage menu)
Trim/Dial Setting
RACING MENU