FUTABA T10PX - Page 169

169
Returntotableofcontents
TELEMETRYMENU
Communication port.
Cover
Sensor Reload
When using multiple sensors of the same type, the sensors must be registered in the
WUDQVPLWWHU&RQQHFWDOOWKHVHQVRUVWREHXVHGWRWKH73;DVVKRZQLQWKH¿JXUHEH-
low and register them by the following procedure. The ID of each sensor is registered
in the transmitter.
To load the sensor, connect all sensors to be used to the T10PX communication
port, as shown below. The power supply is unnecessary. Also, to clear all sensor
UHJLVWUDWLRQH[HFXWHWKLV>5HORDG@IXQFWLRQZLWKRXWFRQQHFWLQJWKHVHQVRU7KHUHJ-
istration is cleared, and all the slots in the sensor list are unregistered.
All the sensors to be used
are connected to the
T10PX.
Sensor
Sensor
Sensor
1
(Start slot selection)
Tap the [Reload]. The confirmation screen will be displayed. To execute, tap [Yes] to hear an
electronic sound and finish setting. To cancel, select [No] and tap it. If "Success" appears on
the screen, reload is complete.
2
When finished, return to the Telemetry screen by pressing the HOME button.
How to change start slot and set empty slot