FUTABA T10PX - Page 170

170
Returntotableofcontents
TELEMETRYMENU
Communication port.
Cover
Sensor Register
7KLVIXQFWLRQUHJLVWHUVDGGLWLRQDOVHQVRUV&RQQHFWWKHVHQVRUDVVKRZQLQWKH¿JXUH
and register as follows. The sensor ID is registered in the transmitter.
This function is set when adding one telemetry sensor of the same type.
Connecting S.BUS/S.BUS2
servo connector to the
T10PX.
Sensor (The battery is not necessary)
Confirm sensor connection
1
(Start slot selection)
Tap the [Register]. The confirmation screen will be displayed. To execute, tap [Yes] to hear
an electronic sound and finish setting. To cancel, select [No] and tap it. If "Success" appears
on the screen, registration is complete. If registering a sensor that has already been regis-
tered is attempted, the message "Failed; The same sensor has been registered" will be dis-
played. If the message "Failed; The connected sensor is not ready." is displayed, check the
sensor connection. If it is securely connected, the sensor or the transmitter may be faulty.
2
When finished, return to the Telemetry screen by pressing the HOME button.
How to change start slot and set empty slot