FUTABA T10PX - Page 171

171
Returntotableofcontents
TELEMETRYMENU
Change Slot
This procedure changes the slot number of the one registered sensor. Connect the sen-
VRUDVVKRZQLQWKH¿JXUHSUHYLRXVSDJHDQGFKDQJHVORWQXPEHU
This function is set when using multiple telemetry sensors of the same type.
1
(Change)
Tap the [Change slot]. The sensor details screen is displayed. Tap the [Read]. The confirma-
tion screen will be displayed. To execute, tap [Yes] to hear an electronic sound and finish
reading. To cancel, select [No] and tap it. If "Reading succeeded" appears and the current
sensor information is displayed.
2
(Number setting)
Tap the value button of the [Start slot #].
Value input buttons appear on the screen.
Use the [+] and [-] buttons to set the start
slot number.
3
Tap the [Write]. When "Writing succeeded"
message is displayed, the number change is
completed.
Sensor slot change
Setting button
Setting with the [+] and [-] but-
tons.
4
When finished, return to the Sensor screen by pressing the HOME button.