FUTABA T16IZ SUPER

101
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Telemetry:Receiver[Ext.battery]
ŤƏƄƕƐŃƖƈƗŃ
1. Tap Alarm and choose from Buzzer, Voice,
and Inhibit.
2. Choose "Inhibit" for Vibrator if not using the
vibrator alarm. If using vibrator, choose one
of the three types.
3. Tap to the Limit [4.0 V] item.
$GMXVWWKHUDWHXVLQJWKHʈʈʈʆʆʆ
buttons.
Initial value: 4.0 V
Adjustment range: 0.0 V~100.0 V
:KHQWKHVFUHHQLVWDSSHGIRURQHVHFRQGWKHUDWHLVUHVHW
to the initial value.
5. To terminate the input and return to the
original state, push the HOME/EXIT button.
Ext.battery
voltage
Setsthevoltageon
whichthealarm
operates.
↓ The"down"arrow
willindicatethatan
alarmwillsoundwhen
thevoltagedropsto
belowthesetting.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
AllowsSpeechtobe
turnedONorOFF.
ŏ7DSWKH>5HFHLYHU@EXWWRQLQWKH7HOHPHWU\VFUHHQ
to call the setup screen shown below.
Max.andmin.values
sincethepower
wasturnedONwill
display.
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
Displaying data from the EXT
battery voltage port
7KH(;792/7VFUHHQZLOOGLVSOD\WKHGDWDIURP
WKH(;7EDWWHU\RXWSXWIURPWKH56%RU
56%UHFHLYHU
,QRUGHUWRXVHWKLVIXQFWLRQLW
is necessary to connect external voltage connector
RIWKH56%RU56%UHFHLYHUWRD&$
59,1RU6%69WRWKHEDWWHU\\RXGHVLUHWR
measure the voltage of
WKH(;7EDWWHU\.
<RXZLOOEHDOHUWHGE\DQDODUPRUYLEUDWLRQLIWKH
voltage set by you is exceeded.
*It cannot be used in FASST mode and S-FHSS mode.
2QO\UHFHLYHUYROWDJHDQG(;7YROWDJHFDQEHXVHGLQ
FASSTest12CH mode.
7KH)$667HVW&+7)+66PRGHFDQXVHDOOWKHWHOHPHWU\
functions.
*CA-RVIN-700mustbeinstalledintheaircraft.
ŏ5HWXUQWR
Linkage menu