FUTABA T16IZ SUPER

129
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Datareset
Model memory setting data reset. (by item)
7KLVIXQFWLRQLVGHVLJQHGWRDOORZ\RXWRUHVHW
selected portions or all of the settings saved in
WKHDFWLYHPRGHOPHPRU\<RXPD\LQGLYLGXDOO\
FKRRVHWRUHVHWWKHIROORZLQJVHWVRIGDWD
Trim (All condition):
Reset the digital trim setting.
$OOWKHFRQGLWLRQVRUWKHFRQGLWLRQFXUUHQWO\
EHLQJGLVSOD\HGWKHHQWLUHJURXSIRUJURXSVHWWLQJ
can be selected.
*The trim step amount and trim rate are not reset.
Trim (Current and Group condition):
Reset the digital trim setting.
&XUUHQWFRQGLWLRQJURXSFRQGLWLRQFDQEH
selected.
ŧƄƗƄŃƕƈƖƈƗƗƌƑƊŃƐƈƗƋƒƇ
1. Tap to the item you want to reset and tap
the screen.
$FRQ¿UPDWLRQPHVVDJHDSSHDUV
*The trim step amount and trim rate are not reset.
Model menu setting:
5HVHWVDOOWKHIXQFWLRQVLQWKH0RGHOPHQXH[FHSW
condition select.
All model setting:
5HVHWVDOO/LQNDJHDQG0RGHOPHQXIXQFWLRQV
H[FHSWIRUV\VWHPW\SHPRGHOVHOHFWPRGHOW\SH
IXQFWLRQQDPHDQGWHOHPHWU\VHWWLQJ
Function Name:
A function name is reset.
Telemetry:
Reset the telemetry setting.
[Trim (All condition)]: Resets only the Trim (all
conditions)
[Trim(Current and Group condition)]: Resets
only the data of Trim (condition in use and all
the conditions set to group mode)
[Model menu setting]: Resets all the functions
in the model menu, except the condition
selection functions.
[All model setting]: Resets all the functions in
the linkage menu and model menu except
the frequency, model select, and model
type functions.
[Function name]: Resets only the function
name functions.
[Telemetry]: Resets only the teremetry
functions.
2. Execute reset by tapping the "Yes".
ŏ6HOHFW>'DWDUHVHW@DWWKHOLQNDJHPHQXDQGFDOO
the setup screen shown below.
CAUTION
ThrottleReverse
■ Onlythethrottlechannel(CH3)initialsettingis
REV(reverse).ThoroughlychecktheHiandLow
directionsoftheengineormotorusedandbecareful
thattheydonotsuddenlyrunatfullspeed.Even
afterdatareset,CH3isreversed
.
CAUTION
NeverengagetheDataresetfunction
whiletheengineisstartingorthe
motordrivewiringisconnected.
■ Sudden,abruptspinningofpropellersorrotorsis
extremelydangerous.
ŏ5HWXUQWR/LQNDJHPHQX