EasyManuals Logo

FUTABA T16IZ SUPER Full Manual

FUTABA T16IZ SUPER
246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #201 background imageLoading...
Page #201 background image
201
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
SwashBasic
SwashBasic
H-1
SwashType
ELE
PIT AIL
H3-120
ELE
PIT AIL
H3-140
ELE
PIT AIL
H3-90
ELE2
ELE
PIT AIL
H4-00
ELE2
FRONT
ELE
PIT
AIL
H4-45
ELE
PIT
AIL
H-1
(4) SWASH Type: Swash change to plate type
Select the swash plate type. When you change the setting, other data is
initialized.
Setting:H-1
/
H3-120
/
H3-140
/
H3-90
/
H4-00
/
H4-45   Initialsetting:H3-120
WARNING
All of the swash plate parameters are reset when the swash plate
type is changed. Doing so eliminates any possible errors or mal
-
functions within the system. After changing the swash plate type,
Please proceed through the entire setup process once again before
attempting to fly the model.
AIL --------------------Aileron servo
ELE ----------------- Elevator servo
PIT ---------Collective pitch servo
ELE2 ---- Second elevator servo
Your transmitter should be reset to the default settings and the swash plate
type selected with the transmitter should be set to "H-1" or single servo
mode. All CCPM mixing is set up and handled in the CGY, and the transmit
-
ter functions should not be used. Before starting model set-up, be sure that
all dual rates, pitch curve, and endpoint values are set to 100/100.
(5) Servo Dir #: Servo direction #
Using different servo combinations will create the proper swash plate servo
movement in electronic CCPM models (eCCPM). In the H3-xx swash
mode, three of the swash servos directions are changed by pressing the
Servo Dir #. Choose the combination number which produces level swash
plate travel with a collective pitch input from the transmitter. There are 8
combination choices for the H3-xx swash mode. On H4-xx swash mode,
there are 16 combination choices. After selecting the combination number,
aileron, elevator, pitch, and 2nd elevator servo parameters are automati
-
cally set.
Note: Occasionally the aileron or elevator function directions are reversed
even though collective pitch direction is correct. In this case, use the "SWS.
Dir parameter on the following screen (4/6) to fix this later.

Other manuals for FUTABA T16IZ SUPER

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FUTABA T16IZ SUPER and is the answer not in the manual?

FUTABA T16IZ SUPER Specifications

General IconGeneral
Channels16
Frequency2.4GHz
TelemetryYes
Voice AlertsYes
SD Card SlotYes
USB PortYes
Trainer PortYes
DSC PortYes
ModulationS-FHSS
Battery2000mAh
Model Memory30 models
Display4.3 inch color TFT LCD touch screen

Related product manuals