FUTABA T16IZ SUPER

108
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
*It cannot be used in FASST mode and S-FHSS mode.
2QO\UHFHLYHUYROWDJHDQG(;7YROWDJHFDQEHXVHGLQ
FASSTest12CH mode.
7KH)$667HVW&+7)+66PRGHFDQXVHDOOWKHWHOHPHWU\
functions.
Telemetry:Voltage[Battery]
Displaying data from the receiver battery voltage
,QWKLVVFUHHQWKHEDWWHU\YROWDJHRIDUHFHLYHULV
displayed.
,ILWEHFRPHVKLJKHURUORZHUWKDQWKHVHWWLQDQ
DODUPDQGRUYLEUDWLRQZLOODOHUW\RX
Batteryvoltage
Setsthevoltageon
whichthealarm
operates.
↓ The"down"arrow
willindicatethatan
alarmwillsoundwhen
thevoltagedropsto
belowthesetting.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
AllowsSpeechtobe
turnedONorOFF.
ŏ7DSWKH>9ROWDJH@EXWWRQLQWKH7HOHPHWU\VFUHHQ
to call the setup screen shown below.
Max.andmin.values
sincethepower
wasturnedONwill
display.
,QWKLVVFUHHQWKHEDWWHU\YROWDJHLVGLVSOD\HG
,QRUGHUWRXVHWKLVIXQFWLRQLWLVQHFHVVDU\WR
FRQQHFW([WHUQDOYROWDJHFRQQHFWRURI56%
56%
⇔
6%69
⇔
Battery
6%69PHDVXUHVWZREDWWHULHV7KHSRZHU
EDWWHU\FRQQHFWHGWRWZROLQHVLVGLVSOD\HGRQ(;7
92/77KHEDWWHU\IRUUHFHLYHUVFRQQHFWHGWR3
lines is displayed here.
*SBS-01Vmustbeinstalledintheaircraft.
＜
Two examples of wiring are shown
＞
5HIHUWRWKHPDQXDORI6%69IRUWKHGHWDLOVRI
ZLULQJ
WR6%86
SRUW
WR6%86
SRUW
56%
56%
Drivebattery1
（EXTBattery)
Receiverbattery
Receiverbattery
Drivebattery2
（EXTBattery)
Drivebattery1
（EXTBattery)
Drivebattery2
（EXTBattery)
6ZLWFK
Powersupplies
forservos
$QRWKHUSRZHU
VXSSO\+XE
S.BUS2
servos
Twodrivebatteriesaremeasured(R7108SBuse)
Twodrivebatteriesandpowersuppliesforservosaremeasured(R7108SBuse)
●Batteryvoltagemeasurementforreceivers[R7108SBuse]
●Thedrivebattery1ismeasuredinanEXTport[R7108SBuse]
●Thedrivebattery2ismeasuredinanEXTline[SBS-01Vuse]
●Batteryvoltagemeasurementforreceivers[R7108SBuse]
●Thedrivebattery1ismeasuredinanEXTport[R7108SBuse]
●Thedrivebattery2ismeasuredinanEXTline[SBS-01Vuse]
●Thevoltageforservosismeasuredinapowersupplyline[SBS-01Vuse]
Normal Line
Normal Line
EXT Line
EXT Line
*SBS-01Vmeasurestwovoltage.Onecorrespondstohighvoltages,suchasadrivebattery,
withanEXTline.Anotherisanormallineandismeasurementofthebatteryforreceiversofa
lineconnectedto3Pconnector,orthebatteryforservos.
ŤƏƄƕƐŃƖƈƗŃ
1. Tap Alarm and choose from Buzzer,
Voice, and Inhibit.
2. Choose "Inhibit" for Vibrator if not using
the vibrator alarm. If using vibrator,
choose one of the three types.
3. Tap to the Limit [4.0 V] item.
$GMXVWWKHUDWHXVLQJWKHʈʈʈʆ
ʆʆEXWWRQV
Initial value: 4.0 V
Adjustment range: 0.0 V~100.0 V
:KHQWKHVFUHHQLVWDSSHGIRURQHVHFRQGWKHUDWHLV
reset to the initial value.
5. To terminate the input and return to
the original state, push the HOME/EXIT
button.
Vibratorchoicesare
type1-3,andInhibit.
ŏ5HWXUQWR
Linkage menu