FUTABA T16IZ SUPER

62
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
S.BUS/S.BUS2
Servo
S.BUS/S.BUS2
Servo
ųƕƒƆƈƇƘƕƈŃƉƒƕŃƆƋƄƑƊƌƑƊŃŶőťŸŶŃƖƈƕƙƒŃ
ƖƈƗƗƌƑƊ
1. Select [S.Bus servo] of the System menu.
:LUHWKHVHUYRDVVKRZQLQWKHÀJXUHDERYH
3. Press [Read]. The ID and current setting of
that servo are displayed.
S.Busservo
S.BUS servo setting
ŏ&DOOWKHIROORZLQJVHWWLQJVFUHHQE\SUHVVLQJWKH
[S.BUS Servo] button in the System menu.
ٴ ŶƈƕƙƒŃŬŧŃƑƘƐƅƈƕ
,I\RXXVHPXOWLSOH6%86VHUYRVRQO\WKHGHVLUHG
servo in the group can be set by entering the ID of
WKDWVSHFL¿FVHUYR
$Q6%86VHUYRFDQPHPRUL]HWKHFKDQQHODQG
various settings you input. Servo setting can be
SHUIRUPHGRQWKH7,=683(5VFUHHQE\ZLULQJ
WKHVHUYRDVVKRZQLQWKH¿JXUH
:LWKVRPH6%86VHUYRVWKHUHDUHVRPHIXQFWLRQVZKLFK
FDQQRWEHXVHG,IDIXQFWLRQFDQQRWEHXVHGWKHGLVSOD\
VFUHHQZLOOFKDQJH2QO\WKHIXQFWLRQZKLFKFDQEHXVHGE\
DVHUYRLVGLVSOD\HG
$IWHUUHDGLQJFRPSOHWLRQZLWKFRQQHFWLRQRIWKHDERYH
¿JXUHLIDVWLFNLVPRYHGVHUYRRSHUDWLRQFDQEHWHVWHG
SERVO SERVO
3-way hub
or Y-harnesses
SERVO SERVO SERVO
4. When multiple servos are connected change
[INH] at the right side of the ID number on the
screen to [ACT] and enter the ID of the servo
you want to set.
5. Set each item. (Please see the next page.)
6. Press [Write]. The settings are changed.
ŏ5HWXUQWR6\VWHPPHQX