FUTABA T16IZ SUPER

122
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Telemetrydatalogfunction
Telemetry data has been adapted to the log function which is recorded at the microSD card.
【Settingmethod】
①
Open the linkage menu Tele. setting screen.
②
Log recording can be started and stopped by operating a switch. The Logging switch is selected.
③
The log output interval can be set.
* The data to be recorded is updated at the time set by Linkage menu
→
System Type screen D/L interval. For
example, when the log output interval is 1 second and the D/L interval is 2 seconds the same data is over
lapped and
recorded twice
.
【Operationmethod】
①
Insert the microSD card into the card slot.
②
Set the switch set by Log Start/Stop Switch to ON. A beep sounds and a log file is created and recording of the
telemetry data begins.
AbsolutelyneverremovethemicroSDcardwhilelogdataisbeingrecorded.
③
Set the switch set by Logging switch to OFF. A beeping sound is generated and recording of the telemetry data stops.
④
Turn off the transmitter power and remove the microSD card.
■
Log file
A log file is created in the microSD card LOG folder. Two files with the same filename, but a different e
xtension are
created.
(Example: 00001234.FLI, 00001234.FLD)
■
Extension FLI: Slot allocation information file
■
Extension FLD: Log data file
*When copying or moving a log file, always select both the .FLI file and .FLD file.
Log files can be converted to CSV format by using the telemetry log converter available at the Futaba website.
■
Notes
◇
Altimeter altitude data and GPS distance and altitude data output with the point that time logging started as the
reference (0 m). When the transmitter preset position and the log start position are different, the transmitter displa
y
and the log data displa
y will also be different. The altitude and distance from the take-off position can be recorded by
starting logging immediately after take-off.
◇
The transmitter gear ratio or number of fins setting is not reflected in the speedometer log data (speed).
Multiply the
gear r
atio or number of fins by the speed data.
◇
When the microSD card becomes full, recording stops and does not resume even if logging is restarted.
Tele.setting
ŏ7DSWKH>7HOHVHWWLQJ@EXWWRQLQWKH/LQNDJHPHQX
to call the setup screen shown below.
Speech interval set , data logging of telemetry.
6HWWKHVSHHFKLQWHUYDORIWHOHPHWU\GDWDDQGWKH
logging of telemetry data to a microSD card at
chosen intervals.
Telemetry data can be checked on your PC after a
ÀLJKW
Setsthespeechinterval
Initialvalue:0sec.
Adjustmentrange0-30sec.
ŏ5HWXUQWR
Linkage menu