184
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Throttlehold
This function sets the throttle cut position for
autorotation. The throttle position can also be set to
an idling position. Setting of these 2 positions can
EHVHOHFWHGE\VZLWFK7KLVDOORZVXVHIRUVZLWFKLQJ
during training.
Example of use
ŏ6LQFHWKURWWOHKROGKDVPRGHV&XWDQG
(Idle), using it in the Idling mode during
training and in the Cut mode when
stopping the engine at contest, etc. is
convenient.
Note: When throttle hold is set to ON in the normal
condition, throttle hold acts and the throttle servo
is deactivated. Always set throttle hold to ON in the
hold condition.
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ2SHUDWLRQPRGHVHOHFWLRQ
Manual mode(Manual): The throttle hold
function is operated by switch operation
only.
Auto mode(Auto): The throttle hold function
operation is linked to the throttle stick
position.
Auto position setting: When the auto mode is
selected, the throttle position (auto position)
can be selected. Move the throttle stick to
the position you want to set and tap the
screen. (Auto position is displayed.)
ŏ+ROGSRVLWLRQDGMXVWPHQW
Throttle Hold (Cut) sets the throttle cut
position. Adjust it so that the carburetor is fully
closed.
Throttle Hold (Idle): Make this adjustment to
maintain idling for training. Adjustments can
be made based on the throttle curve idle
position.
ŏ7KHWKURWWOHVHUYRRSHUDWLQJVSHHGFDQEH
adjusted. (Speed)
ŏ7KURWWOHFXWRUWUDLQLQJIXQFWLRQFDQEH
switched by hold function selector switch.
ŲƓƈƕƄƗƌƒƑŃƓƕƈƆƄƘƗƌƒƑƖ
WARNING
Whenstartingtheengine,confirmthat
theidleupconditionandthrottlehold
conditionareOFF.
ŏ6HOHFW>7KURWWOHKROG@DWWKHPRGHO
menu and call the setup screen shown
below.
Currentposition
Holdposition
Enginecutsetting Engineidlesetting
Settotheengine
stopposition.
Settotheidling
position.
ŏ5HWXUQWR0RGHOPHQX