185
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Swashmixing
7KHVZDVKPL[IXQFWLRQLVXVHGWRFRUUHFWWKHVZDVK
SODWHLQWKHDLOHURQUROOGLUHFWLRQDQGHOHYDWRU
F\FOLFSLWFKFRUUHVSRQGLQJWRHDFKRSHUDWLRQRI
each condition.
$GMXVWPHQWE\LQGHSHQGHQWFXUYHIRUDLOHURQ
HOHYDWRUDQGSLWFKRSHUDWLRQVLVSRVVLEOH7KH
RSHUDWLRQFDQEHVPRRWKO\DGMXVWHGE\FDOOLQJXS
WKH³&XUYHVHWXS´VFUHHQE\WDSSLQJWKHPL[LQJ
item that corresponds to the mixing and direction
ZKLFKQHHGVFRUUHFWLRQ
Example of use
ŏ$VDQH[DPSOHXVHVZDVKPL[LQJWRFRUUHFW
undesirable tendencies in the roll direction.
ŏ)RUDFRQGLWLRQZKLFKXVHV$LOHURQWR
Elevator, set this function to ON. When
raising the nose at a right roll, when the
Rate B side is input and the right aileron is
operated, the elevator moves to the down
side. Tune by adjusting the Rate. For right
roll, adjust to the rate A side.
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ:KHQXVLQJWKLVIXQFWLRQ7DS>,1+@ 21 LV
displayed.)
ŏ:KHQ\RXZDQWWRVHWWKHVDPHFRQWHQWVDW
other conditions, select the group mode.
When you want to set the selected condition
only, select the single mode (initial setting).
ŏ7KHFRUUHFWLRQUDWHFDQEHVHWE\FXUYH
ŏ $VZLWFKFDQEHVHW
When [--] is set, the swash mixing function is
operated by merely selecting the condition.
When setting an [ON]/[OFF] switch, tap to
the [--] item and tap the screen to call the
selection screen and set the switch and its
ON position.
ŏ6HOHFW>6ZDVKPL[LQJ@DWWKHPRGHO
menu and call the setup screen shown
below.
●Mixingcurvesetting
*Foradescriptionofthe
curvesettingmethod,
seethedescriptionat
thebackofthismanual.
Conditiongroup/single
modeselection(Gr./
Sngl)
ŏ5HWXUQWR0RGHOPHQX