FUTABA T16IZ SUPER

139
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
AIL
AIL
AIL3
(ChipAileron)
AIL4
(ChipAileron)
AIL1
(MainAileron)
AIL2
(MainAileron)
FLP2
(CamberFlap)
FLP1
(CamberFlap)
AIL → Camberflap
[Corresponding model type]: Airplane/
JOLGHUDLOHURQVÁDSVRUPRUH
7KLVPL[RSHUDWHVWKHFDPEHUIODSV)/3
in the aileron mode. When the aileron stick
LVPDQLSXODWHGWKHDLOHURQVDQGFDPEHUIODSV
perform aileron operation simultaneously and
the operation characteristic of the roll axis is
improved.
ŏ7KHDLOHURQOHIWULJKWPL[LQJUDWHRIHDFKÁDSVHUYR
FDQEHÀQHWXQHG
ŏ$PL[LQJFXUYHFDQEHVHW
ŏ$Q212))VZLWFKFDQEHVHW
ŏ/LQNLQJLVSRVVLEOH/LQNWKLVPL[WRRWKHUPL[HV
Adjustmentofeach
flapservo
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ7DS>,1+@
(ON is displayed.)
ŏ:KHQVHWWLQJDVZLWFKWDSWKH>@LWHPRI
the switch and tap the screen to call the
selection screen, and then select the switch
and set its ON direction. (Always ON at "--"
setting)
(For a description of the switch selection
method, see the the back of this manual.)
ŏ7DSWKHOHIWRUULJKWLWHPRIHDFKÁDSVHUYR
Adjust the mixing rate.
:KHQWKHPL[LQJGLUHFWLRQLVUHYHUVHGE\WKHOLQNDJH
DGMXVWPHQWVFDQEHPDGHE\FKDQJLQJWKHPL[LQJUDWH
SRODULW\RU
ŏ$PL[LQJFXUYHFDQEHVHWSDJH
(For a description of the mixing curve setting
method, see the description at the back of
this manual.)
ŏ7RVHWOLQNLQJWDSWKH>/LQN@LWHP
Set it to ON and tap the screen.
ŏ6HOHFW>$,/ń&DPEHUIODS@DWWKH
model menu and call the setup
screen shown below.
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
Left/rightoverall
adjustmentatRateA
andRateB
Activatethefunctionby
tappingthe[INH].
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Tosetlinking,tapto
the[OFF]item
ŏ5HWXUQWR0RGHOPHQX