FUTABA T16IZ SUPER

158
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
[Corresponding model type]: Airplane/glider general
Acceleration
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ $FFHOHUDWLRQUDWHVHWWLQJ5DWH
ŏ 7KHUHWXUQWLPHDIWHURSHUDWLRQ'DPSLQJ
can be set.
ŏ 7KHRSHUDWLRQSRLQWDWDFFHOHUDWLRQ
and deceleration can be set. When an
operation point is exceeded, acceleration is
performed.
ŏ6HOHFW>$FFHOHUDWLRQ@DWWKHPRGHO
menu and call the setup screen shown
below.
$FFHOHUDWLRQVHWWLQJFDQEHSHUIRUPHGDW(OHYDWRU
(OHYDWRUĺ&DPEHUDQG$LOHURQĺ5XGGHU*OLGHU
RQO\
ŏ7KLVVHWWLQJLVGLYLGHGLQWRHOHYDWRUVHWWLQJDQGFDPEHU
setting. The setting method is the same.
ŏ&DPEHUVHWWLQJVHWVWKHDFFHOHUDWLRQIXQFWLRQIRU(OH
to camber mixing. Setting is not performed when Ele to
camber mixing is INH.
ŏ7KHDFFHOHUDWLRQIXQFWLRQFDQEHVHWIRUERWKWKHXS
side and down side.
ŏ)XQFWLRQ212))VZLWFKVHWWLQJLVSHUIRUPHGIRU
$LOHURQń5XGGHUVHWWLQJRQO\
ŏ$LOHURQń5XGGHUVHWWLQJLVDFFHOHUDWLRQ
IXQFWLRQVHWWLQJIRU$LOHURQń5XGGHUPL[LQJ,WLVQRW
SHUIRUPHGZKHQ$LOHURQń5XGGHUPL[LQJLV,1+
Note: When using the acceleration function,
since the servo stroke is large, make your
settings so there is no binding of your linkage.
Operationuptothis
rangewillinitiate
acceleration.
Actposition
Theratetheangle
increases.
Tonextpage
2/3:Elevator → Camber
3/3:Aileron → Rudder
Thereturntimeafteroperation(Damping)
canbeset.
（Firstreturn）1 〜 100（Slowreturn）
（Accelerationdoesn'tfunctionas0.）
Whenusingthis
function,Tap[INH].
(ONisdisplayed.)
Conditiongroup/
singlemodeselection
(Gr./Sngl)
Currentposition
ŏ5HWXUQWR0RGHOPHQX