FUTABA T16IZ SUPER

176
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŏ7DSWKH>3URJPL[HV@EXWWRQLQWKH0RGHOPHQXWRFDOO
the setup screen shown below.
Program.mixes
Program mixing which can be freely customized. Up to 10
mixings can be used for each condition. [All model types]
Programmable mixing may be used to correct
XQGHVLUHGWHQGHQFLHVRIWKHDLUFUDIWDQGLWPD\DOVR
EHXVHGIRUXQXVXDOFRQWUROFRQ¿JXUDWLRQV0L[LQJ
PHDQVWKDWWKHPRWLRQRIDFRPPDQGFKDQQHO
FDOOHGWKHPDVWHULVDGGHGWRWKHPRWLRQRIWKH
PL[HGFKDQQHOFDOOHGVODYH
<RXPD\FKRRVHWRKDYHWKH0DVWHUVWULPDGGHGWR
WKH6ODYHFKDQQHOUHVSRQVHLI\RXGHVLUH7ULP
VHWWLQJ7KHPL[LQJFXUYHFDQEHFKDQJHGVR
that the undesired tendencies can be corrected
H൵HFWLYHO\E\VHWWLQJWKH(;3(;33RLQWPRGHV
2൵VHWW\SHPL[LQJDSSOLHVD¿[HGR൵VHWRUSUHVHW
to the programmed channel servo operation and
may control up to four circuits simultaneously.
7KH3URJUDPPDEOHPL[LQJLQFOXGHVDSRZHUIXOOLQN
IXQFWLRQZKLFKDOORZV3URJUDPPDEOHPL[LQJWREH
OLQNHGZLWKWKHVSHFLDOPL[LQJIXQFWLRQVRUZLWK
other programmable mixing functions. The link
IXQFWLRQFDQEHVHWXSIRU0DVWHUDQG6ODYHFKDQQHO
individually.
Finetuningtrim
setting
Theontime(start/stop
time)canbesetupto4
seconds.Itisusefulfor
landinggearcontrolofthe
jetorscaleplane,etc.
● Group/singlemode
switch(Gr./Sngl)
(Formoreinformation,
seethedescription
atthebackofthis
manual.)
Mixing/Offsetmode
switch
Afterthisfunctionis
activated,themaster
andslavefunction
names(oroffsetmixing)
aredisplayed.
● Operationcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionatthebackof
thismanual.)
Activatethefunctionby
tappingthe[INH].
TrimmodesettingON/OFF.
TheON/OFFswitchof
prog.mixesischosen.
Masterfunction
(orStick,Switch,Dial)
ischosen.
Slavefunctionischosen.
Servospeedsetting
ŏ5HWXUQWR0RGHOPHQX