FUTABA T16IZ SUPER

41
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŶőťŸŶŒŶőťŸŶŕŃƇƈƙƌƆƈŃƖƈƗƗƌƑƊ
S.BUS/S.BUS2 servos or a telemetry sensor can be connected directly to the T16IZ SUPER. Channel
setting and other data can be entered for the S.BUS/S.BUS2 servos or sensors.
6%866%86VHUYR
6%866%86
GHYLFH
6%866%86
GHYLFH
7HOHPHWU\VHQVRU
1. Connect the S.BUS device as shown in the
ÀJXUH
2. Turn on the transmitter power.
3. Call the setup screen.
Servo: System Menu
ĺ
S.BUS servo
Sensor: Linkage Menu
ĺ
Sensor
4. Perform setting in accordance with each
screen.
5. This sets the channel and other data for each
S.BUS servo, or telemetry device to be used
with the S.BUS device or receiver.
WARNING
DonotdisconnectorturntransmitterpowerOFF
whileS.BUSservoandtelemetrysensordatais
beingsaved.
■ S.BUSservoandsensorsavedatawillbelost,
resultinginmalfunction.