FUTABA T16IZ SUPER

44
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
LINK
Aftersetting,pressaHOME/EXITbutton
ŤƉƗƈƕŃƖƈƗƗƌƑƊ
,IWKHUHDUHPDQ\)$667HVW7)+66V\VWHPV
WXUQHGRQDURXQG\RXUUHFHLYHULWPLJKWQRW
OLQNWR\RXUWUDQVPLWWHU,QWKLVFDVHHYHQLIWKH
UHFHLYHUV/('VWD\VVROLGJUHHQXQIRUWXQDWHO\
the receiver might have established a link
to one of other transmitters. This is very
dangerous if you do not notice this situation.
,QRUGHUWRDYRLGWKHSUREOHPZHVWURQJO\
UHFRPPHQG\RXWRGRXEOHFKHFNZKHWKHU
your receiver is really under control by your
transmitter by giving the stick input and then
checking the servo response.
'RQRWSHUIRUPWKHOLQNLQJRSHUDWLRQZKHQ
the drive motor is connected or the engine is
running.
10. When a telemetry function is enabled,
the receiving interval (down-link interval)
of sensor data can be changed. If a D/
L interval is increased, the response of the
sensor data display becomes slower, but
stick response will improve.
Initial value: 1.0s
Adjustment range: 0.1s~2.0s
9. ACT will be chosen if telemetry is used.
It is INH when not using it.
:KHQ\RXXVHWZRUHFHLYHUVSOHDVHEHVXUHWR
setup a "Rx1" and "Rx2" in the "dual" mode.
*Telemetry function cannot be used for the 2nd
receiver.
→
)$667HVW&+
*Telemetry function cannot be used for the dual
receiver.
→
7)+66)$667HVW&+
<RXPXVWOLQNRQHUHFHLYHUDWDWLPH,IERWK
SRZHUVXSSOLHVWRWKHUHFHLYHUVDUHVZLWFKHGRQ
VLPXOWDQHRXVO\GDWDLVUHFHLYHGLQFRUUHFWO\E\
the transmitter.
<RXFDQQRWOLQNWKUHHUHFHLYHUV
/LQNLVUHTXLUHGZKHQDV\VWHPW\SHLV
changed.
/LQNLQJLVUHTXLUHGZKHQHYHUDQHZPRGHOLV
made.
)$66708/7,)$667&+FDQQRWEH
selected for Europe.
WARNING
Afterthelinkingisdone,pleasecycle
receiverpowerandcheckthatthe
receivertobelinkedisreallyunderthe
controlofthetransmitter.
Donotperformthelinkingprocedure
withmotor'smainwireconnectedor
withtheengineoperatingasitmay
resultinseriousinjury.