FUTABA T16IZ SUPER

60
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Stick mode selection and J1-J4 sticks calibration
Thestickissetat
neutral
Fullrightand
fullbottom
Fullleftand
fulltop
H/Wsetting
8VXDOO\WKLV+:VHWWLQJLVXQQHFHVVDU\
Please perform this calibration only if a change at
the center of a stick should arise after prolonged use.
2. Choose the stick to calibrate right and left.
3. The stick is set at neutral and the [Set neutral]
button is tapped.
ūƒƚŃƗƒŃŦƄƏƌƅƕƄƗƈŃ
1. Tap the "Calibration" button.
3OHDVHGRQRWSUHVVWKHVWLFNWRR¿UPO\LQDQ\GLUHFWLRQZKHQ
doing the calibration.
&KHFNDIWHUFDOLEUDWLRQWRPDNHVXUHWKDWQHXWUDOLVWKH
ERWWRPULJKWVLGHLVDQGWKHWRSOHIWVLGHLV
ŏ7DSWKH>&DOLEUDWLRQ@EXWWRQLQWKH6\VWHP
menu to call the setup screen shown below.
ŏ5HWXUQWR
System menu
4. The stick is held at full right and full bottom
(diagonal). The [Set endpoint] button is
tapped.
5. The stick is held at full left and full top
(diagonal). The [Set endpoint] button is
tapped.
Tapped
Tapped
Tapped
ŃŶƗƌƆƎŃƐƒƇƈ
0RGHFDQEHFKRVHQ
%XWLWLVQWFKDQJHGXQWLOGDWDLVUHVHW
To change the mode the stick ratchet
PXVWEHFKDQJHG5HTXHVWWKDWWKLV
EHGRQHE\)XWDED6HUYLFH&KDUJHG
PRGL¿FDWLRQ
AIL
THR
RUD
ELE
MODE1
AIL
ELE
RUD
THR
MODE2
AIL
THR
RUD
ELE
MODE3
AIL
ELE
RUD
THR
MODE4