FUTABA T16IZ SUPER

82
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Systemtype
■ FASSTest18CH---
■ FASSTest12CH---
■ FASSTMULTI---
■ FASST7CH---FASST-7CHsystemreceivermode.Upto7channelscanbeused.
■ T-FHSSAir---
■ S-FHSS---S-FHSSsystemreceivermode.Upto8channelscanbeused.
FASSTestsystemreceivermode.Applicablewiththetelemetrysensorunit.Up
to18channels(linear16+ON/OFF2)canbeused.
T-FHSSsystemreceivermode.Applicablewiththetelemetrysensorunit.Upto
18channels(linear16+ON/OFF2)canbeused.
FASSTestsystemreceivermode.Applicablewithreceivervoltagedisplay.Upto
12channels(linear10+ON/OFF2)canbeused.TelemetrySensorcannotbeused,
buttheresponsespeedisfasterthanthatofthe18CHmode.
FASST-MULTIsystemreceivermode.Upto18channels(linear16+ON/OFF2)
canbeused.
•
Analog servos cannot be used with the R7208SB (R7308SB) in the FASSTest 12CH mode.
ŦŵŶũŃųƕƒƗƒƆƒƏŃƉƒƕŃŷťŶ
7,=683(5KDVEHHQPDGHFRPSDWLEOHZLWK
WKH&56)7%6SURWRFRO
*Bidirectional communication function of CRSF is not supported.
:KHQXVLQJ&56)WKH6%86VHUYRVHWWLQJIXQFWLRQDQG
>5HORDG@>5HJLVWHU@>&KDQJHVORW@IXQFWLRQVFDQQRWEHXVHG
:KHQVHWWLQJ6%86VHUYRDQGVHQVRUVHW&56)WR,1+
Tapthe"CRSF"buttonto[ON].Asignal
conformingtotheCRSFstandardis
outputfromtheS.BUSsettingconnector
(S.I/F)ofthetransmitter.
WARNING
Futabaisnotresponsiblefordamage
sustainedbycombinationwith
partsotherthanFutabaGenuine
equipment.
ŏ&DOOSDJHIURPWKH>6\VWHPW\SH@PHQX
*FASST MULTI/FASST 7CH cannot be selected for Europe.