FUTABA T16IZ SUPER

85
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Tappingthiswillchange
INHtoeitherOFForON
andactivated.
Tappingthiswillpullupthe
hardwareselectionscreen.
Selecttheidledownswitch
andON-OFFdirection.
Thisisthecurrentpositionbarforthe
throttlestick.Throttlecutwillonly
functionwhenthethrottlestickismore
thanhalfwayintothelowthrottlerange.
Thisistheidledown
throttleposition.Tapping
thiswilldisplayvalueinput
buttonson-screen.Setthe
engine'smax.lowposition.
Range:
（↑）-100 〜 +100（↓）
Pressingandholdinga
valuewillresetitto0.
Idledown
Lowers the engine idling speed.
7KH,GOHGRZQIXQFWLRQORZHUVWKHHQJLQHVLGOH
E\ÀLSSLQJDVZLWFKZLWKWKHWKURWWOHVWLFNDWLGOH
The action is not functional at high throttle to avoid
DFFLGHQWDOGHDGVWLFNV7KHVZLWFK¶VORFDWLRQDQG
GLUHFWLRQPXVWEHFKRVHQDVLWGHIDXOWVWR
−− "
.
ŏ6HOHFW>,GOHGRZQ@DWWKHOLQNDJHPHQX
and call the setup screen shown below.
ŬƇƏƈŃƇƒƚƑŃƖƈƗƗƌƑƊŃƓƕƒƆƈƇƘƕƈ
1. Tap the "INH" button to activate the Idle
down function.
2. Idle down function switch setting:
Tap the "--" button to call the <Hardware
select> screen, and then select the switch
and its ON direction.
(For a detailed description of the selection
method, see [Switch selection method] at
the back of this manual.)
ŏ5HWXUQWR/LQNDJHPHQX
3. Offset rate setting:
Tap the offset rate button. Value input
buttons appear on the screen.
Use these buttons to adjust the offset rate.
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHa
EHFRPHVDQLGOHXS
To exit the setting, tap the [Idle down]
button.
Landing
Idling,lower
Offsetrate