FUTABA T16IZ SUPER

95
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
RegisteredsensorSlotNumber
Thisiswhatdisplayswhenno
sensorisregisteredinaslot.
Tappingtheslotandselecting
"-----------"willerasewhateverwas
registeredthere,freeingupthe
slot.
Taptheslottodisplay
sensorswhichcanbeused
forthestartslot.Tapto
registerthesensor.
SensorID:Multipleusageofsensors
ofthesametyperequiresanID
beinput.Tappingthiswillallow
formanualinput,butseethenext
pageabouthowtoperformauto-
registrationviasensorregistration.
Sensor
Various telemetry sensors setting
This screen registers the telemetry sensors used
ZLWKWKHWUDQVPLWWHU:KHQRQO\RQHRIDFHUWDLQ
W\SHRIVHQVRULVXVHGWKLVVHWWLQJLVXQQHFHVVDU\
and the sensor can be used by simply connecting it
to the S.BUS2 port of the transmitter.
:KHQXVLQJRUPRUHRIWKHVDPHNLQGRIVHQVRU
they must be registered here.
[What is a slot?]
Servos are classified by CH, but sensors are
FODVVL¿HGLQXQLWVFDOOHG³VORW´7KHUHDUHVORWVIURP
No. 1 to No. 31.
Altitude sensors, GPS sensors and other data
sensor units may use multiple slots.
When using a sensor which uses two or more
slots, the required number of slots is automatically
assigned by setting up a start slot.
When 2 or more of the same kind of sensor are
used, the sensors themselves must allocate unused
slots and memorize that slot.
ŏ7DSWKH>6HQVRU@EXWWRQLQWKH/LQNDJHPHQX
to call the setup screen shown below.