FUTABA T16IZ SUPER

98
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
)RUVRPHWUDQVPLWWHUVHJ7.ZKHQWKHVWDUWVORWRID
VHQVRULVFKDQJHGWKHVHQVRUFDQQRWEHXVHG
WARNING
This procedure changes the slot number of one
registered sensor.
ŶƈƑƖƒƕŃƖƏƒƗŃƆƋƄƑƊƈ
1. Connect the sensor to the T16IZ SUPER as
VKRZQLQWKHÀJXUHDERYH
2. Tap “Change slot” on page 3/3 of the
<Sensor> screen.
3. Tap “Read”.
4. A sensor details screen appears.
5. The current start slot is displayed. To change
a start slot, a
＋
Ɇ

button, tap.
（
Cannot be
set to a slot that cannot be allocated like the
table of all pages.
）
6. Tap to the “Write”.
Sensor:Changeslot
Thispageissetwhenusingmultipletelemetrysensors
ofthesametype.
SENSOR
ŏ&DOOSDJHIURPWKH>6HQVRU@PHQX
ŏ7DSWKH>&KDQJHVORW@EXWWRQ
in the Sensor screen to call the
setup screen shown below.
ŏ5HWXUQWR
Linkage menu
Donotdisconnectorturntransmitter
powerOFFwhiletelemetrysensor
data
isbeingsaved.
Sensorsavedatawillbelost,resultingin
malfunction.