Futurecom VR - Declaration of Conformity; Important Safety Information; Notice to Users (FCC;ISED)

8G093X01 R5
VR Programming Guide
August 2022 Page 15 of 144
Declaration of Conformity
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation.
Changes or modifications not expressly approved by Futurecom Systems Group, ULC. could void
the User’s authority to operate the equipment.
Important Safety Information
The DVRS Repeater is intended for use in occupational / controlled conditions, where users have
full knowledge of the operator exposure and can exercise control over the operator exposure to
meet FCC/ISED limits. This radio is NOT authorized for general population, consumer, or any
other use.
Notice to Users (FCC/ISED)
To satisfy FCC/ISED RF exposure requirements for mobile transmitting devices, refer to the RF
Safety Booklet
[1]
for TX – RX duty cycle and a separation distance between the antenna of this
device and persons during operation. To ensure compliance, operations at closer than this
distance is not allowed.
Futurecom requires the P25 DVRS operator to ensure FCC/ISED Requirements for Radio
Frequency Exposure are met. The minimum distance between all possible personnel and the
body of the DVRS equipped vehicle is specified in the RF Safety Booklet
[2]
. Failure to observe the
Maximum Permissible Exposure (MPE) distance exclusion area around the antenna may expose
persons within this area to RF energy above the FCC exposure limit for bystanders (general
population).
It is the responsibility of the repeater operator to ensure that MPR limits are observed at all times
during repeater transmissions. The repeater operator must ensure at all times that no person
comes within MPE distance from the antenna.
[1]
Refer to RF Safety Booklet available on the Futurecom website.
[2]
Refer to RF Safety Booklet available on the Futurecom website.