20
Charging the Battery
1. Make sure the camera power is off.
2. Slide the battery/SD Memory Card cover into the direction of the [OPEN] arrow.
3. Insert the battery, noting correct polarity (+ and -).
4. Slide the battery lock lever to adjust the battery.
5. Close the battery/SD Memory Card cover firmly.
6. Connect one end of the AC power adapter to the DC IN 5V terminal.
7. Connect the other end of the AC power adapter to a power outlet.
Charging start: Green indicator
Charging end: Indicator off
Stand by: Orange indicator
Replace a new battery: Red indicator
Note:
Make sure to use only the AC power adapter specified for the camera. Damage caused by
the use of an incorrect adapter is not covered under the warranty.
When the charging is not started even if proceeding the operation above, press power
button on at any mode after LCD indication appears, then turn the power off.
Never use the battery unspecified for the camera.
Do not place the camera in hot temperature. Use it at room temperature.
To Next Page
Loading...
Need help?
General