EasyManua.ls Logo

Gateway DC-T50 - Changing the Focus

Gateway DC-T50
73 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
Changing the Focus
1. Set the mode dial to one of [ ], [ P], [ Tv ], [ Av ], [ M ], [ ], [ ], [ ] ,
[
] and power on the camera.
2. Toggle the [ ] Focus button.
The selected focus mode is displayed on the LCD monitor.
[no indication]: Normal Auto Focus (2.6ft (0.8m) to infinity).
[
]: Macro Auto Focus (0.3ft (0.09m) to infinity/
Wide, 1ft (0.3m) to infinity/Tele).
[
]: The camera will focus on the subjects
at a distance of infinity to take photos.
[3m]: The camera will focus on subjects
in a distance of 9.8ft (3m) to take photos.
[1m]: The camera will focus on subjects in
a distance of 3.3ft (1m) to take photos.
3. Compose the picture.
4. Press the shutter down halfway, then press it down fully.
Note:
When shooting a close-up in Macro mode, use the LCD monitor to compose your shot,
avoiding the off-center parallax phenomenon.
There is not a distinct point (subject range) at which Normal mode is favored over Macro
mode; take in image in both optical modes and compare the results.
After a Macro shot is taken DO NOT FORGET to reset the lens to the normal position.

Table of Contents