EasyManuals Logo

Gateway DC-T50 User Manual

Gateway DC-T50
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
28
Note:
After an image is taken using the self-timer, the self-timer mode is turned off.
The self-timer cannot be used in the continuous capture mode.
The self-timer is only available for 2 or 10 seconds delay in [ ] mode. The
camera automatically starts to recording after 2 or 10 seconds.
Using the Flash
The flash is designed to function automatically when lighting conditions warrant the
use of a flash. You can take an image using a flash mode suitable to your circumstances.
If you change the flash mode, the camera will retain that setting even if the camera
is turned off.
1. Set the mode dial to one of [
], [P], [Tv], [Av], [M]
and power on the camera.
2. Press the [
] button repeatedly until your desired
flash mode appears.
When you toggle the flash button at [ ] mode,
the available flash modes are displayed in the
following order.
3. Compose the picture and press the shutter button down halfway, then press it
down fully.
Note:
After the flash fires, it takes approximately 5 seconds to 10 seconds to be ready for the
next shot. The indicator turns solid orange while the flash is charging.
[ No display ] Auto [ ] Red-Eye Forced Flash
[ ] Suppressed Flash [ ] Forced Flash

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gateway DC-T50 and is the answer not in the manual?

Gateway DC-T50 Specifications

General IconGeneral
BrandGateway
ModelDC-T50
CategoryDigital Camera
LanguageEnglish