27
Using the Self-timer
The [ ] self-timer button can select the capturing mode between “OFF” (default)
and “Self timer (2 sec., 10 sec., 10+2 sec. or Interval)”.
[2 sec.] The camera automatically takes a picture after two seconds delay.
[10 sec.] The camera automatically takes a picture after ten seconds delay.
[10+2 sec.] The camera automatically takes a picture after ten seconds delay,
and takes again after two seconds.
In case the flash light capacitor is not charged up, the second take
can be done two seconds after charging.
[Interval] The camera automatically takes a picture every preset time till
the media is full or the battery is empty.
Activate the self-timer by pressing the shutter button. After selecting this mode, self-
timer icon displays on the LCD monitor and then the LED on the front panel blinks
fast for the last 3 seconds. Using the self-timer allows you to get into the scene when
taking group images.
1. Secure the camera to a tripod or place it on a
stable surface.
2. Set the mode dial to one of [
], [ P ], [ Tv ], [ Av ],
[
M ], [ ], [ ], [ ], [ ] and power on the
camera .
3. Press the [
] button.
When you toggle the self-timer button, the
following are displayed in order:
4. Compose the picture.
5. Press the shutter button down halfway, then press it down fully.
The self-timer function is activated.The photograph is then taken after the preset time.
When the photographs are taken using the LCD monitor, the count down is
displayed.
Off 10 sec 2sec 10+2sec Interval
To Next Page
Loading...
Need help?
General