GE Security TruVision DVR 10 User Manual

Chapter 5: Advanced setup
72 TruVision DVR 10 User Manual
• Subnet mask
• Gateway IP
• Network communication port
• HTTP port
• PPPoE (Point-to-Point Protocol over Ethernet)
• DDNS (Dynamic Domain Name System)
Note: When a network parameter is modified, the TVR 10 will prompt you to save and
reboot the unit.
To display the Network screen, click Network. The Network screen displays as shown
in Figure 27 below.
Figure 27: Network setup
Network settings
Table 19 below describes the Network screen options.
Table 19: Network screen options
Option Description
IP address Specifies the network’s IP address. The IP address configured here must not
conflict with another IP address. If there is a DHCP server within the network,
you can set the IP as “0.0.0.0” then save and reboot the TVR 10. In the reboot
process, the TVR 10 searches the DHCP server and retrieves one dynamic IP
address. This value displays as the dynamic IP address. If the TVR 10 is utilizing
the PPPoE function, the TVR 10 also connects to the Internet and this value
displays as the dynamic internet IP address. Default value is 192.168.111.111.

GE Security TruVision DVR 10 Specifications

General

Brand	GE Security
Model	TruVision DVR 10
Category	DVR
Language	English