Chapter 5: Advanced setup
TruVision DVR 10 User Manual 65
Option Description
Frame Rate Specifies the frame rate for the selected resolution.
Options include: 25 (PAL)/30 (NTSC) 22, 20, 18, 16, 15
，
12, 10, 8, 6, 4, 2, and 1.
Pre-Event Time This option is used if you have the motion detection and/or external alarms
enabled. Pre-event time refers to the time recorded before a motion or external
alarm is triggered and includes the alarm data. If a motion or external alarm
occurs and you have set the pre-event time to 5 seconds, the TVR 10 will record
and save up to 5 seconds prior to the alarm event. Pre-event time options
include: No Prerecord, 5 (default), 10, 15, 20, 25, 30 seconds, and Max Prerecord.
Max Prerecord lets you save all data in the Prerecord buffer.
Pre-event time relates to the bit rate in that the lower the bit rate, the longer the
actual pre-event time.
Post-Event Time This option is used if you have the motion detection and/or external alarms
enabled. When an external or motion alarm is cleared, the TVR 10 will continue
recording based on the value specified in this option. Options include: 5 (default),
10, 30 seconds, 1, 2, 5, and 10 minutes.
Record Enables or disables recording for the selected camera.
Schedule Defines a recording schedule when you enable camera recording.
When you modify the camera recording schedule, you must reboot TVR 10 to
implement the changes.
Defining a recording schedule
When enabling a camera for recording, you can define a recording schedule for the
selected cameras. You will be prompted to reboot the TVR 10 after making any
schedule modifications. Use the Recording Schedule screen to define a schedule as
shown in Figure 24 below.
Figure 24: Recording schedule screen
To Next Page
Loading...
Need help?
General