APPENDIX D: MISCELLANEOUS REVISION HISTORY
C70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUAL D-3
D
Table D-4: Major changes for C70 manual version AE3 (English)
Table D-5: Major changes for C70 manual version AE1 (English)
Table D-6: Major changes for C70 manual version AC1 (English)
10-5 Added Convert Device Settings section
10-7 Added Copy Settings to Other Device section
10-15 Added Replace Front Panel section for retrofit with the new graphical front panel
Page Description
--- General revision
2- Updated order codes
10-5 Added Copy Settings to Other Device section
Page Description
--- General revision
--- Added routable GOOSE content in chapters 2 and 5
4- Added Engineer content
5- Updated IEC 61850 content
A- Updated FlexAnalog table for most UR products
Page Description
--- General revision. Added online help and updated generic online help.
--- Deleted EAC logo from title page and deleted EAC certification from Approvals specifications because document not
translated into Russian
--- Added Breaker Arcing Current content to product description, specifications, FlexLogic operands table, settings, FlexElement
tables, actual values, FlexAnalog table, features per product table, Modbus memory map, IMD table
--- Added Teleprotection content to specifications, FlexLogic operands table, settings (two places), actual values, clear records
section in Commands chapter, features per product table, Modbus memory map
--- Updated number of Capacitor Control elements, decreasing from four to three, in FlexLogic operands table, settings, actual
values, FlexAnalog table, features per product table, Modbus memory map
--- Updated Disconnect (Breaker) Switch number from 24 to 12 in FlexLogic operands table, settings, features per product table,
Modbus memory map
--- Updated Breaker Failure number from 1 to 3 in FlexLogic operands table, settings, feature per product table, Modbus memory
map
--- Update Neutral Instantaneous Overcurrent number from 12 to 6 in FlexLogic operands table, settings, features per product
table, Modbus memory map
--- Updated Neutral Time Overcurrent (TOC) number from 6 to 3 in FlexLogic operands table, settings, features per product table,
Modbus memory map
--- Updated Phase Time Overcurrent (TOC) number from 6 to 3 in FlexLogic operands table, settings, features per product table,
Modbus memory map
--- Updated number of Phase Instantaneous Overcurrent elements in FlexLogic operands table, settings, features per product
table, Modbus memory map
2- Updated several specifications, such as TOC, IOC, number of FlexLogic lines
4-30 Added FlexLogic Design and Monitoring using Engineer section to end of Interfaces chapter
5-38 Added PRT FUNCTION settings in Network section to enable/disable each Ethernet port
5-49 Updated IEC 61850 section
5-61 Added Support for Routable GOOSE section
5-156 Added Phase TOC I2t FlexLogic operands to the FlexLogic operand table for C70
5-169 Updated number of FlexLogic lines from 512 to 1024 in FlexLogic Equation Editor settings section
5-180 Added I2t content to Phase TOC settings section and added logic diagram specific to C70
10-1 Added Monitoring section
Page Description
To Next Page
Loading...
