GE Corometrics 250cx Series

Revision C 250cx Series Maternal/Fetal Monitor 4-55
2036947-001
Maintenance: Preventative Maintenance Inspection Report
Preventative Maintenance Inspection Report
Customer________________________ Customer Number________________ Date ____________________
FE________________________ FE ID ___________________Call Number __________________________
Equipment Serial Number __________________________ Software Revision CPU _________ DSP: ________
Configuration
Model 256cx__________ Model 259cx __________ Fetal Movement Detection (FMD) __________
Tools Required
Visual Inspection
Inspect the following for excess wear and/or signs of damage. (Refer to “Visual
Inspection” on page 4-4)
• Digital Multimeter • Static-Free Work Surface
• Plastic Alignment Tool • Mild Soap/Water Solution
• Standard Hand Tools • Isopropyl Alcohol
• Leakage Current Tester • Baum Manometer
• Leg Plate (1590AAO with 1442AAO adapter cable)
• FECG/MECG Adapter (1442AAO)
• Model 325 Simulator with Cables
• Baum Test Connector
• ESD Mat and Wristband
• 250cx Operator’s Manual (2020550-001)
•SpO
2
Leakage Cable (2006036)
F AC Power Cord F MSpO
2
Cable/Sensor
F Ultrasound Transducer F Connectors
F MECG Patient Cable F Interconnect Cables
F Leg Plate F Chassis
F Tocotransducer F 2116 Keyboard (if used)
F IUPC Transducer F Front Panel Switches
F IUPC Intermediate Cable F Internal Harnesses/Connectors
F Remote Marker F Power Supply Fan
F NIBP Hose/Cuff F FECG, MECG “Y” Adapter Cable (1442AAO)