To Next Page

To Previous Page

4-6 250cx Series Maternal/Fetal Monitor Revision C

2036947-001

Maintenance: Cleaning

Display

To clean the display screen, use a soft, clean cloth dampened with a glass cleaner.

Do not spray the glass cleaner directly onto the display. Do not use alcohol or

hospital disinfectants like Cidex* or Betadine.

Tocotransducer and Ultrasound Transducer

CAUTIONS

ABRASION—Do not use abrasive cloth, sharp objects, or

abrasive cleaners.

ALCOHOL—Do not use Alcohol in cleaning solutions.

DISCONNECTION—Detach the transducers from the monitor.

NOTE: Only Nautilus transducers are immersible.

1. Dampen a cloth or paper towel with one of the following products; then wring out

until only slightly wet:

 Sodium Hypochlorite 5.25% (Bleach) diluted 10:1

 Cidex*

 Sporicidin*

 Soap and water

2. Rub soiled area until clean, taking care not to excessively wet the

tocotransducer diaphragm seal. Rub around the seal.

3. Dry with a soft, dry cloth.

Leg Plates and MECG Cables

CAUTIONS

ABRASION—Do not use abrasive cloth, sharp objects, or

abrasive cleaners.

ALCOHOL—Do not use Alcohol in cleaning solutions.

DISCONNECTION—Detach the cables/legplate from the

monitor.

IMMERSION—Do not immerse cables or hold under running

water.

*Trademarked

Other manuals for GE Corometrics 250cx Series

Questions and Answers:

Need help?

Do you have a question about the GE Corometrics 250cx Series and is the answer not in the manual?

General