3-20 250cx Series Maternal/Fetal Monitor Revision C
2036947-001
Installation: Printing System Setup Information
Store Current To Hospital
Select this option if you wish to store your current monitor settings as your hospital’s
preferred default settings. When you select this option, the
Default Settings:
softkey
reflects the change (i.e.,
Default Settings:
change to
Hospital
).
Printing System Setup Information
Use the Trim Knob to select the
PrintAll
softkey on the bottom of
Install Options Screen 1
to see an overall summary of the monitor’s setup screens. A screen capture of each
system setup screen (user and service) is printed on the strip chart paper. The following
screen summaries are printed:
Diagnostic Control
Communications Setup
Install Options
General Setup
Master Alarm Setup
Vital Signs History
MSpO
2
Setup
MHR/P Setup
NIBP Setup
FECG Setup
US Setup
US2 Setup
NOTE: The FECG, US, and US2 Setup screens are shown together in one group. In
addition, the HR Offset field is separated on this summary screen, since it
may appear on either the US or the US2 Setup screen—depending on the
active connectors. See sample printout below.
Install Options Portion of System Setup Printout
1
Values are removed from the NIBP area of the display only; values are still retained in memory for display and
printing in the Maternal Vital Signs History screen.
To Next Page
Loading...
Need help?
General
