To Next Page

To Previous Page

2-14 250cx Series Maternal/Fetal Monitor Revision C

2036947-001

Equipment Overview: Optional Components

Canadian Standards Associations CSA 22.2 No. 125, or

International Electrotechnical Commission EN60601-1.

Optional Components

Software Upgrades

To install a purchased option, a software utility program uses one of the monitor’s

RS-232 serial ports. Each upgrade CD contains the software upgrade. The

instructions for running the upgrade are on the CD. Refer to Chapter 6, “Parts List,

Drawings, and Replacement” to order a kit.

Adding Spectra Alerts

The monitor can be upgraded to include Spectra Alerts. Refer to Appendix D of the

Corometrics 250cx Series Operator’s Manual

for more information.

Adding Fetal Movement Detection

The monitor may be upgraded to include Fetal Movement Detection. Contact your

GE Service Representative for further information.

Peripheral Components

Nellcor

Puritan Bennett Model N-200 Maternal Pulse Oximeter

Through this interface, MSpO

readings provided by an NPB Model N-200 are

printed at selected intervals on the strip chart paper of the 250cx Series Monitor.

When the recorder is on, each reading is printed in the annotation area between the

top and bottom grids. A filled diamond marker, above the data, marks the time of the

reading and identifies the data source as an external device. The following is an

example annotation:

MSpO

97% P 78

When the recorder is in maternal-only mode, a time stamp and filled diamond mark

precede each reading. A sample annotation looks like this:

11:13 MSpO

97% P 78

To connect the Model N-200:

Other manuals for GE Corometrics 250cx Series

Questions and Answers:

Need help?

Do you have a question about the GE Corometrics 250cx Series and is the answer not in the manual?

General