GE Druck DPI611

Page 16 of 79 [EN] English – K0571 Issue 1
User Manual Druck DPI611
1.10.1 Pump
When you have set the operation to
pressure or vacuum (See Section 1.10),
seal the system (See Section 1.9.2) and
use the pump to set the necessary
pressure or vacuum.
You can then make the last
adjustments with the volume adjuster
(See Section 1.10.2).
1.10.2 Volume Adjuster
This control increases or decreases the
pressure/vacuum.
Before you seal the system (See Section
1.9.2), turn this control to the necessary
position:
• For equal adjustment, turn it to the
middle of its range.
• For maximum adjustment, turn it
fully clockwise or
counterclockwise.
When you have set the necessary
pressure or vacuum with the pump
(See Section 1.10.1), use the volume
adjuster to make the fine adjustments.
Figure 1-6
Pump
Figure 1-7
Volume Adjuster