GE Druck DPI611

Page 9 of 79 [EN] English – K0571 Issue 1
User Manual Druck DPI611
1.5 ELECTRICAL WARNINGS
• The DC input to the DPI611 is rated at 5V (+/-5%) 4 Amps.
• External circuits should have appropriate insulation to the
mains.
• To prevent electrical shocks or damage to the instrument, do
not connect more than 30V CAT I between the terminals or
between the terminals and the ground (earth).
• This instrument uses standard AA size batteries. To prevent an
explosion or fire do not short circuit.
• The power supply input range to the optional power supply
unit is 100 – 260Vac, 50 to 60Hz, 250mA, installation category
CAT II.
• When using the optional power supply unit as position the
power supply so as not to obstruct the supply disconnecting
device.
• Note that the operating and storage temperature range of
the optional PSU does not match that of the DPI611. Mains
PSU operating temperature range 0°C to +40°C, storage
temperature range -40°C to +70°C.
• To make sure the display shows the correct data, disconnect
the test leads before power is set to ON or changing to
another measure or source function.
• Keep the leads free from all contaminants.