GE Druck DPI611

Page 30 of 79 [EN] English – K0571 Issue 1
User Manual Druck DPI611
Table 2-1
Step Procedure
1
Remove the adaptor
2
Use an applicable seal for the p
ressure connection:
i. NPT type: Use an applicable sealant on the thread.
ii. BSP (parallel) type: We recommend a bonded seal at
the bottom.
3
Attach the adaptor to the device; if necessary use one of
the alternative adaptors listed in Section 1.11
(Accessories), then tighten to the applicable torque.
4
Re
-
attach the adaptor to the test port and tighten it until
it is hand tight only.
b. Procedure (to Remove)
To remove a device, first release the pressure (See
Section 2.1.2). You can then do steps 4, 3, and 1
mentioned in Section 2.1.3 but do the operations in
the reverse order.
2.1.4 Vacuum or Pressure Operation
1 2 3 4 5
Figure 2-5 Vacuum or Pressure operation