Page 62 of 79 [EN] English – K0571 Issue 1
User Manual Druck DPI611
• The tolerance test result is shown a Pass or Fail
icon.
4.2 SET-UP
1. Set the Druck DPI611 channels in the Calibrator function. (See
Section 2.2).
2. Connect the calibrator to the device under test.
3. Enter the Documenting function.
DASHBOARD >> DOCUMENTING
4. Tap the ANALYSIS button.
4.2.1 Define the Reference Channel
1. Tap the channel button that is to be used as the Reference
channel for the analysis.
Figure 4-1 Select Reference Channel
2. Set the channel type to Reference.
3. All other channel settings for that channel are cancelled. All
other active channels are set to Input.
To Next Page
Loading...
