Data Backup
LOGIQ E9
–
User Guide
3-27
Direction 5454884-100 English
Rev. 1
EZBackup and EZMove (continued)
Basically, when you perform the EZBackup or EZMove
procedure, you insert the media (or connect USB HDD if
applicable), the system backs up/moves the images (or reports),
and creates a reference between the patient database and the
media’s volume.
1. Prepare unformatted media or the USB HDD before starting
EZBackup/EZMove.
NOTE: BEFORE starting the EZBackup, select “Unlock All” in Utility
--> Admin --> Logon.
2. Specify the EZBackup/EZMove setup on the Utility -->
System --> Backup/Restore page.
3. To start the EZBackup/EZMove procedure, go to the Patient
menu and select EZBackup/EZMove. The EZBackup/
EZMove Wizard starts.
NOTE: EZBackup/EZMove can take up to 20 minutes (or longer,
depending on the size of the backup). Make sure to
schedule this at the same time daily, when no patients are
scheduled.
4. Verify the information on the first page of the EZBackup/
EZMove Wizard, then press Next.
Full backup options display on the first page of the
EZBackup wizard. If you want to backup all of the exams in
the range (even if the exam was previously backed up,
check this option).
NOTE: You can set the range for EZMove in Utility --> System -->
Backup/Restore --> Move files older than in days.
If you uncheck this option, the system only backs up exams
which have not yet been backed up.
NOTE: If you update an exam which is already backed up, the
exam is also backed up.
To Next Page
Loading...
Need help?
General
