GE HEALTHCARE
DIRECTION 5245279, REVISION 3 LOGIQ™ P6/P6 PRO SERVICE MANUAL
8 - 124 Section 8-4 - Software Installation
8-4-3 Installing Application Software (R2.x.x) (cont’d)
11.)After the installation is completed the system will power off automatically.
NOTE: Some of systems doesn’t power off automatically. In this case, press and hold power button
more than 5 sec. to power off.
NOTE: Do not operate with using mouse or keyboard during installation procedures.
12.)Turn on the system and immediately eject the button on the DVD drive to eject the DVDROM Verify
that the system boots up no error.(It will take a few minutes)
NOTE: Whe application installation is completed, reboot is required.
13.)Shut down the system.
14.)Start the system
Figure 8-186 Installation Complete Message
To Next Page
Loading...
