Performing an Exam
2-14 LOGIQ V2/LOGIQ V1 – User Guide
Direction 5610736-100
Rev. 9
Split Screen
To activate a dual split screen, press L or R.To activate a quad
display, press and hold down L.
To switch between active images, press L/R.
To deactivate, press R until the screen changes.
NOTE: To put a copy of the image on the opposite side when entering
dual split screen, use the “When Entering Dual Image” preset
found on Utility --> Application --> Settings preset page.
Simultaneous mode
While using CFM or PDI, press the L and R keys simultaneously
to display B and B+CFM, or B and B+PDI in real-time on the left
and right side.
It is useful to observe the ROI in B-Mode.
Freezing an Image
To freeze an image,
• Press Freeze. The Freeze key backlight turns green.
If you are in a mixed mode, both screen images freeze
immediately. Deactivating Freeze restarts both modes.
To reactivate the image,
• Press Freeze again. The Freeze key backlight becomes
blue (unfreeze).
NOTE: Deactivating Freeze erases all measurements and calculations
from the display (but not from the worksheet).
Use the Trackball to start CINE after pressing Freeze.
Activating CINE
To activate CINE,
1. Press Freeze.
2. Move the Trackball.
To Next Page
Loading...
Need help?
General
