Moving the System
LOGIQ V2/LOGIQ V1 – User Guide 1-43
Direction 5610736-100 Rev. 9
Moving the System
Before moving the system
When moving or transporting the system, follow the precautions
below to ensure the maximum safety for personnel, the system,
and other equipment.
1. Shut down the system. See ‘Power Off’ on page 1-51 for
more information.
2. Unplug the power cord (if the system is plugged in).
3. Disconnect all cables from off-board peripheral devices
(external printer, etc.) and the ethernet connection from the
console.
NOTE: To prevent damage to the Power Cord, DO NOT pull
excessively on the cord or make sharp bends while
wrapping.
4. Store all probes in their original cases or in soft cloth or foam
to prevent damage.
5. Store sufficient gel and other essential accessories in the
special storage case.
DO NOT attempt to move the console using any cables or
fixtures, such as the probe connectors.
Handle carefully. A drop of more than 5 cm can cause
mechanical damages.
To Next Page
Loading...
Need help?
General
