GE LOGIQ V2

Getting Started
1-56 LOGIQ V2/LOGIQ V1 – User Guide
Direction 5610736-100
Rev. 9
Cable Handling
Take the following precautions with probe cables:
• Do not bend the cable acutely
• Avoid crossing cables between probes.
Disconnecting the Probe
Probes can be disconnected at any time. However, the probe
should not be active when disconnecting the probe.
1. Press the connector locking lever down.
2. Pull the probe connector straight out of the probe port
carefully.
3. Ensure the cable is free.
4. Be sure that the probe head is clean before placing the
probe in its storage box or wall hanging unit.