Overview
LOGIQ V2/LOGIQ V1 – User Guide 1-7
Direction 5610736-100 Rev. 9
Site Requirements
Introduction
Do not attempt to install the system alone. General Electric,
Affiliate, or Distributor Field Engineers and Application
Specialists will install and setup the system. See ‘Contact
Information’ on page 3-73 for more information.
Perform regular preventive maintenance. See ‘System Care and
Maintenance’ on page 3-36 for more information.
The LOGIQ V2/LOGIQ V1 does not contain any operator
serviceable internal components. Ensure that unauthorized
personnel do not tamper with the unit.
Maintain a clean environment. Turn off the system and
disconnect the power cord before cleaning the unit. See
‘Cleaning the system’ on page 3-39 for more information.
Never set liquids on the unit to ensure that liquid does not drip
into the control panel or unit.
All the warnings in the Safety chapter should be read and
understood before operating the unit.
Always use the system on a flat surface in the patient
environment.
The LOGIQ V2/LOGIQ V1 and probe connector are not
waterproof. Do not expose the device to water or any kind of
liquid.
To Next Page
Loading...
Need help?
General
