GE LOGIQ V2

Performing an Exam
2-44 LOGIQ V2/LOGIQ V1 – User Guide
Direction 5610736-100
Rev. 9
Start a Fast Key
1. Press the F6 key to start a Fast Key. The message “Select
the key which the Fast Key is assigned to” displays on the
status bar.
NOTE: The F6 key is ignored if another dialog displays on the
system.
NOTE: If you press F5 after F6, the F6 function cancels and the F5
function is enabled.
2. Press the key assigned to the Fast Key macro. The
message “Fast Key playback is finished” displays on the
status bar when the macro is finished.
To stop the Fast Key during the operation, press F6. The
message “Fast Key playback is cancelled” displays on the
status bar.
NOTE: Select the running speed in the Run Fast Key Speed preset
on Utility -> System -> General.
Backup and Restore the Fast Key
You can backup/restore the Fast Key via Utility -> System ->
Backup/Restore.
To backup, select User Defined Configuration in the Backup
section.
To restore, select User Defined Configuration in the Restore
section.