Measurement and Analysis
LOGIQ V2/LOGIQ V1 – User Guide 2-47
Direction 5610736-100 Rev. 9
Location of Measurement Controls
Figure 2-28. Locating Measurement Controls
1. Clear. During a measurement sequence, erases the
measuring caliper and measurement data from the display.
When not performing a measurement sequence, clears all
calipers and measurements from the display. To remove all
annotations/body markers/arrows, hold down the Clear
button.
2. Measure. Activates a measurement caliper and the
calculation package associated with the currently selected
preset.
3. Set/B Pause. Set fixes the caliper for measurements and
completes the measurement sequence.
4. Trackball. Moves the measurement calipers, selects the
measurement on the Summary Window.
5. Depth/Zoom/Ellipse. Ellipse activates the area/ellipse
measurement function. During the ellipse adjustment, use
the Trackball to increase or decrease the size of the ellipse.
Select Cursor Select to adjust the measurement calipers.
To Next Page
Loading...
