Presets
LOGIQ V2/LOGIQ V1 – User Guide 3-15
Direction 5610736-100 Rev. 9
Data Backup (continued)
To minimize accidental loss of data, perform EZBackup and
Backup on a regular basis.
1. First, perform EZBackup to save the images.
2. Next, perform Backup at Utility -> System -> Backup/
Restore. Enable the following checkboxes under Backup:
• Patient Archive
• Report Archive
• User defined configuration
• Service
Archived data is managed at the individual sites. Performing
data backup (to any device) is recommended.
Make sure to verify the media after writing of data, such as
EZBackup, SaveAs or Export.
Verifying media requires additional time, which varies
depending on the amount of data backed up or exported.
Before deleting a patient or image from the patient screen,
make sure you have saved the data by EZBackup/Backup or
Export and verify that the media transfer of data was
successful.
To Next Page
Loading...
