Presets
LOGIQ V2/LOGIQ V1 – User Guide 3-17
Direction 5610736-100 Rev. 9
EZBackup and EZMove (continued)
You can still do a backup/move daily; but ALWAYS do a patient
archive backup after each move.
Only cancel the backup/move in case of an emergency. The
system completes backing up the current media and then
cancels the operation.
When EZBackup requires more than one disk (CD-R or
DVD-R) for backup, a message appears when the first disk is
full. If you select “Cancel” to stop the backup procedure and
later try EZBackup again, all the data may not be backed up.
Select “Full Backup” on the first EZBackup wizard screen if the
last time you were performing EZBackup you selected
“Cancel”.
If you use EZBackup or EZMove as a “true” patient archive,
you must maintain a separate backup of the patient database
(Patient Archive and Report Archive). If for any reason the
Local Archive - Int HD gets corrupted or the base system
software has to be reloaded, then the patient archive is the
ONLY way to rebuild the EZBackup and EZMove patient
archive.
DO NOT turn off the power while EZBackup is running. The
data may be lost. It may take several hours for EZBackup to
finish, depending on the amount of data being backed up.
The following may give the impression of a lockup, but
EZBackup is continuing in the background.
• The progress bar does not move.
• The screen may become white.
• The hourglass icon keep turning.
To Next Page
Loading...
Need help?
General
